08.24
Soap dispenser holders are making way for the wall mounted soap dispensers! They save valuable counter space and dispatch a measured amount of soap in which way it guarantees that there is no waste and they don’t need to be filled up often. In addition to liquid soap, they can also be filled with shampoo, bath foam and so on. With a lot of advantages, wall soap dispensers are becoming favorites to more and more homes.
If you get a wall mounted soap dispenser to be installed, maybe you can learn something helpful from the following advice.
A soap dispenser can be installed in one of two ways: either use the adhesive, or use the screws that are included with it. The first step is to select a location most suitable for your use. Wall mounted soap dispensers are most often located in the shower where larger amounts of liquid soap are used most often. If needed, you can also install one over the bathroom sink or even over the kitchen sink.
The next step is to thoroughly clean the chosen wall area; rinse well and dry it with a clean, soft cloth. Then, use a clean cloth and a small amount of rubbing alcohol and wipe over the area. The alcohol will remove any soap residue, etc.
Apply the adhesive to the holder and let it set for five minutes. Afterwards position the holder on the wall and press it firmly into place. Wait twenty-four to forty-eight hours (consult the manufacturer’s instructions for details) before you place the dispenser into the holder. Till then, you’ve successfully install the soap dispenser holder.
If you choose to install the soap dispenser by using the screws included with it, the step following choosing a right location is to use a stud finder to find the studs in the area; mark their locations with a pencil. Now, hold the dispenser up to the wall and reposition it so that at least one screw will hit a wall stud. Remember to mark the positions of the holes on the wall by using a pencil. Then drill the holes and install the plastic expanders. Finally, position the holder on the wall and insert the screws. Be careful not to overtighten the screws because they will strip. Now you can place the soap dispenser into the holder.